Reset computer after oil change after oil change


How do you reset computer on 2007 Chevy Silverado after oil change

Not positive 05 is the same but on my 02 you turn the key to the on position and pump the gas pedal 4 times.

Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds.

Please leave feedback!

You can reset most computers by unhooking the battery for a few minutes. I usually leave them for an hour over lunch break.

it will say in your owners manual but i believe you turn your ignition key to the run position not the start. and pump the gas pedal 3 times with in 5 seconds

Information courtesy of synthetic-direct.ca
Chevrolet Suburban/GMC Yukon XL, 2000-05 Chevrolet GMC Trucks Silverado, Sierra, 1999-05 Chevrolet Venture 2000
Turn the ignition key to the RUN position. Fully push and release the accelerator pedal 3 times within 5 seconds. If the CHANGE OIL SOON light flashes 2 times, the system is reset. However if the light comes on and stays on for 5 seconds, the system did not reset. Repeat the procedure if the system does not reset.
Best of luck.
Greg


More: