Sharp t.v. 55" aquios. Tv turns on and sharp logo displays for a few seconds then it turns off for a couple seconds. Then pops back on. Only thing i can get is the logo on the screen. Please help


Good day!!!


please try to count the exact number of blinking lights to diagnose where the fault came from..

Also try to open the cover and look for any bulged capacitors on power supply board..

The Sharp TV model LC32D40U / 41U "Black Screen problem" is a very well known issue. The inverter is losing ground contact which will prevent the back-light from staying on. The solution is to re-tighten six screws on the inverter board. You also would want to clean the copper contacts on then bottom of the inverter where the screws go through. Access to the inverter board will require some disassembly. Plan on taking at least three hours to repair. See the photo for the location of the screws. Use some "blue" locktight" on these six screws. There is actually a Sharp Technical Service Bulletin that describes these screws. Sharp wants you to replace these screws with a newer version. They cost at least $2.50 each! I think my method will work just as good using the "Locktight"_548.jpg_547.jpg

Call Sharp for warrenty repair.This problem very common in Sharp tv.Picture will come on turn power on/off button few times will work.But still under Wareenty call to Sharp to replaced the main Tuner Signal board.

Sounds like corrupted firmware. Contact any service technician to make it confirm. If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/

I have the same problem with my 37" HP which is the same as Sharp Aquos, it's bad backlight inverter boards, the screen comes on for a second then nothing, no menu, no channel change indicator then turn it off and you hear the clicking of the power supply about 10 seconds after.

it has problem in picture tube


More: