Keep getting an F.43 alarm on my Bosch logixx 8 and although i have changed the bushes in the motor, cant reset the board and clear the alarm. Please help


Go to the manufactures website and download the user guide to locate the fault in the problem section

I have found the operating manual online (see link to below off Bosch site) which explains how to do this - looks a bit fiddly by twisting dial and press/hold different buttons. Too complex to repeat in detail here so check out the website:

http://www.boschappliances.com.au/content.asp?document_id=430&category_id=86
from the above page (which I know is not the same model)
- follow the User Manual link
- enter the correct model number (mine is WAS32466)
- select the operating manual instructions (installation manual may also be given)
- see section on Individual Settings / Signal.

Sorted.
Andrew

click on the link below and download the manual,if asked you will have to enter model number or else you can download user manual directly from the link:
bosch user manual
thanks.

Usually means there is water in the base pan and the flood safety has been activated. If you tip the unit forward a touch you will most likely find that water is expelled from the bottom front. The machine should work but obviously the source of the leak has to be found. Check door gasket for tears etc, water valves and drain hoses.
Hope this helps.

Look for user manuals at http://www.user-manual-search.com

F37 is because of operating the unit below specified temperatures.

Pressing the temperature button twice shows a snowflake and sets a defrost function.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question


More: