Model #1045 went dry, after filling, it started flashing 20 even after I filled it. I unpluged it and waited for a few minutes, but it continues to flash 20. What should I do now.


Even if you fill the tank with water, the machine will display this message when it is empty inside (the pipes, heating element, etc.) You need to prime it: run some water through it by running the steamer/hot water wand.  That should take care of it.

Look for a microswitch connected to the lock mechanism at the back of the stove. The switch is probably broken.

my w830 is doing exactly the same thing.

I am usually pretty good at fixing these sort of things so if/when I solve it I will post back here.

I think it is a motor fault - most likely the motor brushes are worn out.

possible cause could be evap canister full of gas causing back up

I have the same problem. The only way to get the TV to come on is to unplug it, but once you get it back on it turns itself off again in a few minutes.


More: