Control valve came apart , screw cap came off inside the slide got it apart but not sure of how it goes back together with out an exploded view to guide me, any help would be great.+


See if their is any help here:
http://h10025.www1.hp.com/ewfrf/wc/product?product=90764&lc=en&cc=us&dlc=en&submit.y=3&submit.x=5〈=en&cc=us

Well.. it's really rather late, so I don't know if you're still trying to put the thing back together, but I was just having issues getting the hammer assembly on mine to work..

Going from this parts list: http://www.shans2003.ru/Article/pi_Crosman_1088-EVP.pdf

Assuming you had the same problem I did:
Start by putting the trigger assembly in (parts 37 and 40, the shorter pin on 40 goes through the holes on 37 as shown in the diagram)
Then insert pin 28 in to the hole that's right at the crook where your thumb rests.
Then part 35 goes over that pin with the little tiny nub pointing towards the back of the gun.
Spring 36 goes over that nub, and slides against the flat spot in the frame.

Pin 27 will then be placed in to the hole just above the hole for pin 28.
Then slide the hammer over said pin. now comes the tricky part. You will need something of moderate length, extremely thin and decently strong, I used an exacto knife. Use your tool of choice to press part 35 back, compressing the spring and push the hammer against the frame.

The two pins on the hammer should be in position such that the hook on the trigger assembly, and the crook on part 35 rest against them.

Once you have that done, keep holding the hammer in place, hook the spring hanging from it over the pin set in the frame. (should be pretty clear which one. and then re-assemble the rest of the gun.

Be warned spring 29 does not like going back in. you will likely feel like you need 3 hands (one for the hammer, one for assembly 60/spring 29 and one to put the frame back on.

Hope it helps.

Hi what model is it you can try this site its called pats small engines

You are probably not going to find assembly instructions. If you can't find all the parts or screws then get another cap. Google " motorcycle salvage yamaha " and you can probably find one at a much lower cost than the dealer would give. By the way, forget any loose screws in the gas tank. The stuff can not get past the fuel valve and filter and are not going to hurt anything.

Please rate this answer. Thanks!

Hi! Here you go!! hope this helps you!ae5521f.gif

What kind of machine are you talking about normally you can get a service manual of the makers website eric


More: